Avaya 03-300686 User Manual
Installing and connecting the mdf and telephones
Advertising
Table of contents
Document Outline
- Installing and Connecting the MDF and Telephones
- Contents
- Chapter 1: Introduction
- Chapter 2: Installing the main distribution frame
- Physical requirements and layout
- Main distribution frame cross-connect fields
- Main distribution frame hardware installation
- Main distribution frame placement
- Main distribution frame labels
- Mounting 110A- or 110P-type terminal blocks on the wall
- Mounting 110P-type terminal blocks on a frame
- Installing Cable Slack Managers
- Chapter 3: Installing the patch panel
- Chapter 4: Media gateway connections to the MDF
- Chapter 5: MDF connections to stations and the public switched telephone network
- Station (telephone) wiring design
- Information outlets
- Station cables
- Closets
- Station circuit distribution from equipment room
- Connected cable station adapters
- Completing a provisioning plan
- Installing sneak current and off premise protection
- Installing the coupled bonding conductor
- Installing and administering the patch cord/jumper
- Chapter 6: Installing and wiring telephones and trunks
- Wiring telephones and trunks
- Connecting telephones
- Connectable telephones and consoles
- Connecting a typical telephone
- Connecting adjunct power
- Connecting an analog station or 2-wire digital station
- Analog tie trunk example
- Digital tie trunk example
- DS1 tie trunk example
- Collocated DS1 interface trunks
- DS1 interface trunks using T1 channel service unit
- Auxiliary connector outputs (MCC1 and SCC1 Media Gateways only)
- Three-pair and four-pair modularity
- Adjunct power connection locations
- Attendant console example
- Connecting external alarm indicators and auxiliary power
- Installing off-premises station wiring
- Off-premises or out-of-building stations
- Off-premises connections
- Emergency transfer units and associated telephones
- 808A Emergency Transfer Panel and telephone installation examples
- Installing external ringing
- Installing the queue warning indicator
- Chapter 7: Installing and wiring telephone power supplies
- 1145B2 power supply
- Important warning for 1145B2 power supply
- Mounting the 1145B2/1146B2 power supply
- Installing the wall-mounting plates
- Mounting the 1146B2 Power Distribution Unit
- Installing the battery mounting/wiring
- Installing the expanded power distribution unit
- Powering up and testing the power supply
- Wiring the 1146B2 Power Distribution Unit
- Resetting LEDs on power distribution unit
- 1152A1 Mid-Span Power Distribution Unit
- 1152B Mid-Span Power Distribution Units
- C360 converged stackable switches
- 1151B1 and 1151B2 Power Supplies
- 1145B2 power supply
- Chapter 8: Testing the complete configuration
- Testing port network equipment
- Checking port network status for each media gateway
- Checking circuit pack configuration
- Testing the TN2312BP Internet Protocol Server Interface circuit pack
- Testing Expansion Interface circuit packs, if used
- Testing time division multiplexing bus for each port network
- Testing expansion interface exchange, if used, for each port network
- Testing telephones and other equipment
- Making test calls
- Testing 302C attendant console
- Testing selector console
- Testing external ringing
- Testing queue warning indicator
- Testing integrated announcement
- Testing music-on-hold
- Testing emergency transfer (Avaya S8700 Multi-Connect only)
- Testing terminating trunk transmission
- Testing connectivity to the LAN
- LED indicators
- Testing port network equipment
- Index