CONTREX MLP-Drive - Manual (Page 185)

D - 1
APPENDIX D: CONTROL PARAMETER
REFERENCE
USER
CODE DESCRIPTION MIN MAX DEFAULT RECORD UNITS
CP-01 Master Setpoint 1 0000 9999 0000 ENG
CP-02 Master Setpoint 2 0000 9999 0000 ENG
CP-03 Follower Setpoint 1 0000 9999 0000 ENG
CP-04 Follower Setpoint 2 0000 9999 0000 ENG
CP-05 Jog Setpoint 0000 9999 50 RPM
CP-06 Direct Setpoint 0 +100 0 %
CP-08 Minimum Limit 0 9999 0 RPM
CP-09 Maximum Limit 0 9999 2000 RPM
CP-10 Alarm 1 Format 0 16 15 CODED
CP-11 Alarm 2 Format 0 16 15 CODED
CP-12 Low Alarm 0000 9999 0000 RPM
CP-13 High Alarm 0000 9999 2000 RPM
CP-14 Ramped Error Alarm 0000 9999 2000 RPM
CP-15 Scaled Error Alarm 0000 9999 2000 RPM
CP-16 Acceleration Time 000.0 600.0 5.0 SEC
CP-17 Deceleration Time 000.0 600.0 5.0 SEC
CP-18 Lag Pulse Limit 0 9999 0 PLSES
CP-19 Lead Pulse Limit 0 9999 0 PLSES
CP-20 Master Eng. Units 0.000 9999 2000 ENG
CP-21 Follower Eng. Units 0.000 9999 1.000 ENG
CP-29 Recovery Multiplier 0 100 0 —
CP-30 PPR Lead 1 9999 60 PPR
CP-31 PPR Feedback 1 9999 60 PPR
CP-33 Max RPM Lead 1 9999 2000 RPM
CP-34 Max RPM Feedback 1 9999 2000 RPM
CP-60 Open Loop 1 2 1 CODED
CP-61 Direct Enable 0 1 0 CODED
CP-62 Inverse Scaling 1 2 1 CODED
CP-64 Display Mode Follower 1 2 2 CODED
CP-65 Gain (Proportional) 0 9999 9000 —
CP-66 Integral 0 9999 2000 —