CONTREX MLP-Drive - Manual (Page 93)

3 - 55
Jog
Jog increases the RPMs at the acceleration rate that you specified in Acceleration Time
(CP-16) until the Jog Setpoint (CP-05) is achieved. When Jog is terminated, there is no
Deceleration Time (CP-17); the drive comes to an immediate stop. The factory default
Control Parameter for Jog is found in Table 3-47. To modify this default parameter,
refer to Table 3-48.
Table 3-47 Default Jog Control Parameters
CP Parameter Name Parameter Value
CP-05 Jog Setpoint 50
Table 3-48 Entering Jog Control Parameters
CP Parameter Name Parameter Value
CP-05 Jog Setpoint Enter the RPM at which you want your
system to operate when it is in Jog.
For information on the Jog Logic Input, refer to Logic Control: Logic Inputs, Jog .