Outgoing ata frame settings – Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual User Manual
Page 146
Teledyne LeCroy
Emulation
144
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Scroll through the available choices in the Destroy Field of Frame list box and check the
field to destroy.
Incoming Open Primitive Response
Check this box, then click the down arrow next to the Primitive list box and choose a
response type. Enter a Delay value.
Figure 2.133: Incoming Open Primitive Response Dialog
Affiliation Setting
Check Clear Affiliation After Command Complete to release device to commands from
other sources, or check Leave Affiliation State Unchanged to retain control of device.
Enable First Burst
Check Enable First Burst to allow first burst.
Task Attribute
Choose Simple, Head of Queue, Ordered, or ACA.
Outgoing ATA Frame Settings
Before selecting Outgoing Frame Settings, select the Types Of Frames and the Frame
Number on which to inject an error. Then check Outgoing Frame in the Generate Error On
area and then the enabled Settings button to display the Outgoing Frame Settings dialog
(see