Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual User Manual
Page 452
Teledyne LeCroy
Sierra Trainer Generation Commands
450
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
PauseTrnScrmblr.
0
When set, the generator pauses the Idle scrambler of
Train/TrainDone pattern.
ReconnectOnRun
0
When “AdvanceConnect” and “ReconnectOnRun”
are set, the “Connect” command forces the Trainer
to disconnect the physical link before executing the
“Connect” command.
When “AdvanceConnect” is not set, this setting does
not affect the Trainer.
AdvanceConnect
0
When set, the Trainer uses the
“PHY Capability” and “SupportSNW” settings,
instead of the “Set Speed” settings, for executing the
“Connect” command.
OutputOffAfterDC
On
Off
If set to On, Trainer puts DC Idle on line when it
detects sync lost on the link.
AutoMode Settings
AutoOOBMode
On
When set, the generator will go through the stages of
bringing up the link automatically, including waiting
for and responding to the device or host it is
connected to.
AutoHoldMode
0
When set, the generator will respond automatically
to Hold requests. Not supported for version 1.1
(reserved).
AutoDMAT
0
When set, the generator will respond automatically
to DMAT requests. Not supported for version 1.1
(reserved).
AutoSpeedNeg
On
When set, the generator will automatically go
throughthe speed negotiation process, for the speed
set in the PINTERFACEC_SERDES register for the
Trainer.
AutoAlignSATA
0
When set, the generator will automatically inserting
the stream 2 Align(0) primitives every 254
DWORD
s, as
specified in the SATA spec.
AutoAlignSAS
On
When set, the generator will automatically inserting
the stream Align primitives every 2048
DWORD
s, as
specified in the SAS spec.Two Align modes can be
turned on simultaneously, to support STP
Setting
Default
Value
Description