Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 259)

Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual 257
Compliance Test (SATA) Teledyne LeCroy
8. To save the failed test traces only, check the Save only failed test traces check box.
9. Enter a path and file name for Report file, or use the default file name and path: 
c:\program files\lecroy\SAS/SATA Protocol Suite\User\SASVerification_Device1.rtf
10. Enter a path and file name for Saved Traces, or use the default folder: 
C:\Program Files\LeCroy\SAS/SATA Protocol Suite\User\
11. After you select tests, click Start.
12. The test runs and, after a brief period, displays the result.
13. To save the current compliance setup for later use, click the Save button to open the
Save As dialog. Assign a meaningful name to the setup and save it as a *.cst
compliance file.
14. To run a previously defined setup, click the Load button and choose a previously
defined setup to run.
For the NACA test, both ports of the SAS device must be connected to two Host Emulation
ports, I1 and I2, using two SATA cables.
Note:
When you are running SAS Verification, you cannot work with Trainer and Emulator while device
is connected to D connector and HBA is connected to H connector.
Note: You must use a Power Expansion Card (ACC‐EXP‐004‐x or ACC‐EXP‐005‐X) for the SATA
Compliance Test. See “Using the Power Expansion Card” on page 30 .
3.6 Compliance Test (SATA)
SATA Verification consists of a set of selectable tests to verify compliance with the
SATA specification.
Note: The Digital Tests and the Phy Tests are documented in the SATA_Digital‐
Device_MOI_LeCroy_1.00_UTD1.4.pdf file in the installed Documents directory.
Note: Connecting to an HBA, while running in Emulation/Trainer mode, will impact test results.
To run a SATA Compliance Test:
1. Select Analysis on the main toolbar and choose Compliance Test to open the SATA
Compliance Test dialog (see Figure 3.74 on page 258 ).