Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual User Manual
Page 206
Advertising
Teledyne LeCroy
Target and Device Emulation
204
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Delay Between Getting HOLD to Sending HOLDA
To enable the Delay between getting HOLD to Sending HOLDA feature perform the
following steps:
1. Enter the value in the Delay between getting HOLD to Sending HOLDA field in the
Settings tab as shown in the figure above.
2. Select the Error Injection tab.
Figure 2.199: SATA: Error Injection Tab
3. Click the Generate periodic error check box.
4. Click the Generate Error on outgoing frame commands check box.
5. Click the Settings button.
The Outgoing FRAME Error Setting dialog displays.
Figure 2.200: SATA: Outgoing FRAME Error Setting Tab
Advertising