Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual User Manual
Page 26
Teledyne LeCroy
Expandability
24
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
3. Connect the OUT Clock connector of Unit 1 to the IN Clock connector of Unit 2 using
the supplied stacking cables. Similarly connect any additional units.
4. Connect the OUT 10‐pin connector of Unit 1 to the IN 10‐pin connector of Unit 2
using the supplied stacking cables. Similarly connect any additional units.
Note:
Unit 1 must be the unit that has the first out connection.
Note:
The Self Test, SAS Verification Test, SATA Compliance Test and Update License functions only
work on unit 1 when the analyzers are set up in cascading mode.
Figure 1.7: Cascading
Figure 1.8: Cascading Correctly
Correct way to connect:
The black color pin of the
ribbon wire is connected
the same way between
2 connectors.
Cascading works correctly
in this case.
Black color pin
of ribbon wire