Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual User Manual
Page 210
Teledyne LeCroy
Target and Device Emulation
208
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Power Management Settings Tab
Start Target Emulator button or select Session > Start Target Emulator to start
emulation.
Figure 2.204: Power Management
1. In the Host Initialized Power Management area, choose whether to support the
report in the Identify page.
2. Specify the response type for PMREQ_P and PMREQ_S, the delay, and Minimum
Number of Response Primitives.
3. In the Device Initiated Power Management area choose whether to support the
report in the Identify page.
4. Define start event by choosing Standby timer expires, STANDBY command
executes, or Link layer remains in IDLE state more than [XXX] ms.
5. Specify time for Abandon request and Wake up after and enter the Standby timer
interval.