Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 381)

Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual 379
Creating a Sequence Teledyne LeCroy
The Action Properties dialog box displays:
1. For the action, select Branch to > New State.
2. Click the OK button to close the Action Properties dialog box.
3. This saves the action and automatically creates an area for State 1 in the scenario.
4. In the State 1 area, click the prompt to add an event. The Event Properties dialog
box appears.
5. Choose the Address Frame event. In the Direction column, select From Target (you
want State 1 to trigger on an Identify Address frame received from the target).
6. Click OK to close the Event Properties dialog box.
7. Click the prompt to add an action for State 1. 
Figure 4.40: Example 7: Adding an Action to the Second State
The Action Properties dialog box displays.
1. In this example, you enter the action Beep, and you set the duration of the beep for
1 second.
2. Click OK to close the Action Properties dialog box.
3. You are finished creating the first sequence. Click the add another sequence prompt
to create an area in the scenario for the second sequence (Sequence 1) (see
Figure 4.41 on page 380 ).