Figure 288 cre – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual

Page 1046

Advertising
background image

990

Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002651-02

43

Ethernet Ring Protection Switching

To configure the ERPS parameters for a ring:

1. Click Administration, ERPS.

2. Select Configure Domain from the Step list.

3. Select Configure Details from the Action list.

4. Configure the ERPS parameters for this node. Note that spanning tree protocol cannot be

configured on the ring ports, nor can these ports be members of a static or dynamic trunk. And
the control VLAN must be unique for each ring. Adjust the protocol timers as required. The RPL
owner must be set on one of the rings. And the administrative status enabled once all of the
other settings have been entered.

5. Click Apply.

FIGURE 288

Creating an ERPS Ring (Primary Ring)

Advertising