Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 179)

Brocade 6910 Ethernet Access Switch Configuration Guide 123
53-1002651-02
6
SNMP Commands
Additional Trap Commands
memory
This command sets an SNMP trap based on configured thresholds for memory utilization. Use the
no form to restore the default setting.
Syntax
memory {rising rising-threshold | falling falling-threshold}
no memory {rising | falling}
rising-threshold - Rising threshold for memory utilization alarm expressed in percentage.
(Range: 1-100)
falling-threshold - Falling threshold for memory utilization alarm expressed in percentage.
(Range: 1-100)
Default Setting
Rising Threshold: 90%
Falling Threshold: 70%
Command Mode
Global Configuration
Command Usage
Once the rising alarm threshold is exceeded, utilization must drop beneath the falling threshold
before the alarm is terminated, and then exceed the rising threshold again before another alarm is
triggered.
Example
Console(config)#memory rising 80
Console(config)#memory falling 60
Console#
Related Commands
“show memory,”
process cpu
This command sets an SNMP trap based on configured thresholds for CPU utilization. Use the no
form to restore the default setting.
Syntax
process cpu {rising rising-threshold | falling falling-threshold}
no process cpu {rising | falling}
rising-threshold - Rising threshold for CPU utilization alarm expressed in percentage.
(Range: 1-100)
falling-threshold - Falling threshold for CPU utilization alarm expressed in percentage.
(Range: 1-100)