Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 898)

842 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
41
Configuring VoIP Traffic
Command Usage
All ports are set to VLAN hybrid mode by default. Prior to enabling VoIP for a port (by setting the VoIP
mode to Auto or Manual as described below), first ensure that VLAN membership is not set to
access mode (see
“Adding Static Members to VLANs” on page 754).
Parameters
These parameters are displayed:
• Auto Detection Status – Enables the automatic detection of VoIP traffic on switch ports.
(Default: Disabled)
• Voice VLAN – Sets the Voice VLAN ID for the network. Only one Voice VLAN is supported and it
must already be created on the switch. (Range: 1-4093)
• Voice VLAN Aging Time – The time after which a port is removed from the Voice VLAN when
VoIP traffic is no longer received on the port. (Range: 5-43200 minutes; Default: 1440
minutes)
NOTE
The Voice VLAN ID cannot be modified when the global Auto Detection Status is enabled.
Interface
To configure global settings for a Voice VLAN:
1. Click Traffic, VoIP.
2. Select Configure Global from the Step list.
3. Enable Auto Detection.
4. Specify the Voice VLAN ID.
5. Adjust the Voice VLAN Aging Time if required.
6. Click Apply.
FIGURE 163 Configuring a Voice VLAN