Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 92)

36 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
3
CLI Command Groups
Simple Network
Management Protocol Activates authentication failure traps; configures community access
strings, and trap receivers 105
Remote Monitoring Supports statistics, history, alarm and event groups 125
Flow Sampling Samples traffic flows, and forwards data to designated collector 133
User Authentication Configures user names and passwords, logon access using local or
remote authentication, management access through the web server,
Telnet server and Secure Shell; as well as port security, IEEE 802.1X port
access control, and restricted access based on specified IP addresses 139
General Security Measures Segregates traffic for clients attached to common data ports; and
prevents unauthorized access by configuring valid static or dynamic
addresses, web authentication, MAC address authentication, filtering
DHCP requests and replies, and discarding invalid ARP responses 189
Access Control List Provides filtering for IPv4 frames (based on address, protocol, TCP/UDP
port number or TCP control code), IPv6 frames (based on address or
DSCP traffic class), or non-IP frames (based on MAC address or Ethernet
type) 233
Interface Configures the connection parameters for all Ethernet ports, aggregated
links, and VLANs 255
Link Aggregation Statically groups multiple ports into a single logical trunk; configures Link
Aggregation Control Protocol for port trunks 285
Mirror Port Mirrors data to another port for analysis without affecting the data
passing through or the performance of the monitored port
297
Rate Limit Controls the maximum rate for traffic transmitted or received on
a port
307
Automatic Traffic Control Configures bounding thresholds for broadcast and multicast
storms which can be used to trigger configured rate limits or to
shut down a port
309
Address Table Configures the address table for filtering specified addresses,
displays current entries, clears the table, or sets the aging time
323
Spanning Tree Configures Spanning Tree settings for the switch 329
ERPS Configures Ethernet Ring Protection Switching for increased
availability of Ethernet rings commonly used in service provider
networks
355
VLANs Configures VLAN settings, and defines port membership for VLAN
groups; also enables or configures private VLANs, protocol VLANs,
voice VLANs, and QinQ tunneling
369
Class of Service Sets port priority for untagged frames, selects strict priority or
weighted round robin, relative weight for each priority queue, also
sets priority for DSCP
415
Quality of Service Configures Differentiated Services 427
Multicast Filtering Configures IGMP multicast filtering, query, profile, and proxy
parameters; specifies ports attached to a multicast router; also
configures multicast VLAN registration
443
Link Layer Discovery
Protocol Configures LLDP settings to enable information discovery about
neighbor devices
499
Connectivity Fault
Management
Configures connectivity monitoring using continuity check
messages, fault verification through loopback messages, and
fault isolation by examining end-to-end connections between
Provider Edge devices or between Customer Edge devices
517
TABLE 8 Command Group Index (Continued)
Command Group Description Page