Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 424)

368 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
19
ERPS Commands
East Port MEP The CFM MEP used to monitor link status on the east port of a ring node
Non-ERPS Device Protect Shows if the RPL owner node is configured to send non-standard health-check
packets when it enters protection state without any link down event having been
detected through SF messages
Propagate TC Shows if the ring is configured to propagate topology change notification messages.
TABLE 81 show erps domain - detailed display description (Continued)
Field Description