Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 717)

Brocade 6910 Ethernet Access Switch Configuration Guide 661
53-1002651-02
32
Navigating the Web Browser Interface
Modify Configures group name and administrative status 752
Edit Member by VLAN Specifies VLAN attributes per VLAN 754
Edit Member by Interface Specifies VLAN attributes per interface 754
Edit Member by Interface Range Specifies VLAN attributes per interface range 754
Dynamic
Configure General Enables GVRP VLAN registration protocol globally 758
Configure Interface Configures GVRP status and timers per interface 758
Show Dynamic VLAN 758
Show VLAN Shows the VLANs this switch has joined through GVRP 758
Show VLAN Member Shows the interfaces assigned to a VLAN through GVRP 758
Tunnel IEEE 802.1Q (QinQ) Tunneling 760
Configure Global Sets tunnel mode for the switch 763
Configure Service Sets a CVLAN to SPVLAN mapping entry 764
Configure Interface Sets the tunnel mode for any participating interface 766
Protocol 767
Configure Protocol 768
Add Creates a protocol group, specifying supported protocols 768
Show Shows configured protocol groups 768
Configure Interface 769
Add Maps a protocol group to a VLAN 769
Show Shows the protocol groups mapped to each VLAN 769
IP Subnet 771
Configure Subnet VLAN
Add Maps IP subnet traffic to a VLAN 771
Show Shows IP subnet to VLAN mapping 771
Configure Interface
Add Maps IP subnet traffic to a port/trunk 773
Show Shows IP subnet to port/trunk mapping 773
MAC-Based 774
Add Maps traffic with specified source MAC address to a VLAN 774
Show Shows source MAC address to VLAN mapping 774
Mirror 775
Add Mirrors traffic from one or more source VLANs to a target port 775
Show Shows mirror list 775
Translation 777
Add Maps VLAN IDs between the customer and service provider 777
TABLE 153 Switch Main Menu (Continued)
Menu Description Page