Figure 87, Confi, Figure 88 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 815
Brocade 6910 Ethernet Access Switch Configuration Guide
759
53-1002651-02
35
IEEE 802.1Q VLANs
Show Dynamic VLAN – Show VLAN Member
•
VLAN – Identifier of a VLAN this switch has joined through GVRP.
•
Interface – Displays a list of ports or trunks which have joined the selected VLAN through
GVRP.
Interface
To configure GVRP on the switch:
1. Click VLAN, Dynamic.
2. Select Configure General from the Step list.
3. Enable or disable GVRP.
4. Click Apply.
FIGURE 87
Configuring Global Status of GVRP
To configure GVRP status and timers on a port or trunk:
1. Click VLAN, Dynamic.
2. Select Configure Interface from the Step list.
3. Set the Interface type to display as Port or Trunk.
4. Modify the GVRP status or timers for any interface.
5. Click Apply.
FIGURE 88
Configuring GVRP for an Interface