Figure 314 t – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 1079
Brocade 6910 Ethernet Access Switch Configuration Guide
1023
53-1002651-02
43
Connectivity Fault Management
Interface
To transmit two-way delay-measure messages:
1. Click Administration, CFM.
2. Select Transmit Delay Measure from the Step list.
3. Select Execute Two-Way DM from the Action list.
4. Select an entry from MD Index and MA Index.
5. Specify the source MEP, the target MEP using either its MEP identifier or MAC address, set the
number of times the delay-measure message is to be sent, the packet size, interval, and
timeout.
6. Click Apply.
FIGURE 314
Transmitting Two-Way Delay-Measure Messages
To transmit one-way delay-measure messages:
1. Click Administration, CFM.
2. Select Transmit Delay Measure from the Step list.
3. Select Execute One-Way DM from the Action list.
4. Select an entry from MD Index and MA Index.
5. Specify the source MEP, the target MEP using either its MEP identifier or MAC address, set the
number of times the delay-measure message is to be sent, the packet size, and interval.
6. Click Apply.