Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 788)

732 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
34
Trunk Configuration
To show the active members of a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Show Member from the Action List.
4. Select a Trunk.
FIGURE 64 Showing Members of a Dynamic Trunk
To configure connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Configure from the Action List.
4. Modify the required interface settings. (See “Configuring by Port List” on page 701 for a
description of the interface settings.)
5. Click Apply.
FIGURE 65 Configuring Connection Settings for Dynamic Trunks