Figure 100 confi, Figure 101 s – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 828
772
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
35
Configuring IP Subnet VLANs
•
Priority – The priority assigned to untagged ingress traffic. (Range: 0-7, where 7 is the highest
priority; Default: 0)
Interface
To map an IP subnet to a VLAN:
1. Click VLAN, IP Subnet.
2. Select Configure IP Subnet from the Step list.
3. Select Add from the Action list.
4. Enter an address in the IP Address field.
5. Enter a mask in the Subnet Mask field.
6. Enter the identifier in the VLAN field. Note that the specified VLAN need not already be
configured.
7. Enter a value to assign to untagged frames in the Priority field.
8. Click Apply.
FIGURE 100
Configuring IP Subnet VLANs
To show the configured IP subnet VLANs:
1. Click VLAN, IP Subnet.
2. Select Configure IP Subnet from the Step list.
3. Select Show from the Action list.
FIGURE 101
Showing IP Subnet VLANs