Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1154)

1098 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
47
Layer 2 IGMP (Snooping and Query)
3. Select the VLAN which will forward all the corresponding multicast traffic, and select the port
or trunk attached to the multicast router.
4. Click Apply.
FIGURE 371 Configuring a Static Interface for a Multicast Router
To show the static interfaces attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Show Static Multicast Router from the Action list.
3. Select the VLAN for which to display this information.
FIGURE 372 Showing Static Interfaces Attached a Multicast Router
To show the all interfaces attached to a multicast router:
1. Click Multicast, IGMP Snooping, Multicast Router.
2. Select Current Multicast Router from the Action list.
3. Select the VLAN for which to display this information. Ports in the selected VLAN which are
attached to a neighboring multicast router/switch are displayed.