Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1065)

Brocade 6910 Ethernet Access Switch Configuration Guide 1009
53-1002651-02
43
Connectivity Fault Management
• Remote MEPs can only be configured if local domain service access points (DSAPs) have
already been created (see
“Configuring Maintenance End Points” on page 1007) at the same
maintenance level and in the same MA. DSAPs are MEPs that exist on the edge of the domain,
and act as primary service access points for end-to-end cross-check, loop-back, and link-trace
functions.
• The MEP cross-check start delay which sets the maximum delay that a device waits for remote
MEPs to come up before starting the cross-check operation can be configured on the
Configure Global page (see
“Configuring Global Settings for CFM” on page 995).
• SNMP traps for continuity check events discovered by cross-check operations can also be
configured on the Configure Global page (see
“Configuring Global Settings for CFM” on
page 995).
Parameters
These parameters are displayed:
• MD Index – Domain index. (Range: 1-65535)
• MA Index – MA identifier. (Range: 1-2147483647)
• MEP ID – Identifier for a maintenance end point which exists on another CFM-enabled device
within the same MA. (Range: 1-8191)
Interface
To configure a remote maintenance end point:
1. Click Administration, CFM.
2. Select Configure Remote MEP from the Step list.
3. Select Add from the Action list.
4. Select an entry from MD Index and MA Index.
5. Specify the remote MEPs which exist on other devices within the same MA.
6. Click Apply.
FIGURE 303 Configuring Remote Maintenance End Points
To show the configured remote maintenance end points:
1. Click Administration, CFM.
2. Select Configure MEP from the Step list.
3. Select Show from the Action list.
4. Select an entry from MD Index and MA Index.