Figure 56, Figure 57 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 783
Advertising
Brocade 6910 Ethernet Access Switch Configuration Guide
727
53-1002651-02
34
Trunk Configuration
FIGURE 56
Creating Static Trunks
To add member ports to a static trunk:
1. Click Interface, Trunk, Static.
2. Select Configure Trunk from the Step list.
3. Select Add Member from the Action list.
4. Select a trunk identifier.
5. Set the unit and port for an additional trunk member.
6. Click Apply.
FIGURE 57
Adding Static Trunks Members
To configure connection parameters for a static trunk:
1. Click Interface, Trunk, Static.
2. Select Configure General from the Step list.
3. Select Configure from the Action list.
4. Modify the required interface settings. (Refer to
on page 701 for a
description of the parameters.)
5. Click Apply.
Advertising