Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 944)

888 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
42
Access Control Lists
• Address Type – Specifies the source IP address. Use “Any” to include all possible addresses,
“Host” to specify a specific host address in the Address field, or “IP” to specify a range of
addresses with the Address and Subnet Mask fields. (Options: Any, Host, IP; Default: Any)
• Source IP Address – Source IP address.
• Source Subnet Mask – A subnet mask containing four integers from 0 to 255, each separated
by a period. The mask uses 1 bits to indicate “match” and 0 bits to indicate “ignore.” The mask
is bitwise ANDed with the specified source IP address, and compared with the address for
each IP packet entering the port(s) to which this ACL has been assigned.
• Time Range – Name of a time range.
Interface
To add rules to a Standard IPv4 ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add Rule from the Action list.
4. Select IP Standard from the Type list.
5. Select the name of an ACL from the Name list.
6. Specify the action (i.e., Permit or Deny).
7. Select the address type (Any, Host, or IP).
8. If you select “Host,” enter a specific address. If you select “IP,” enter a subnet address and the
mask for an address range.
9. Click Apply.
FIGURE 208 Configuring a Standard IPv4 ACL