Figure 52, Figure 53 – Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) User Manual
Page 780
724
Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002651-02
34
Port Configuration
Interface
To configure loopback testing on a port:
1. Click Interface, Port, Ethernet Loopback.
2. Select Configure from the Action list.
3. Select a port from the drop-down list, set the Status to Enabled, and enter one or more VLANs
associated with the port.
4. Click Apply.
FIGURE 52
Performing Loopback Testing
To show the adminstative status of loopback testing for each port, and the associated VLANs:
1. Click Interface, Port, Ethernet Loopback.
2. Select Show Information from the Action list.
3. Select a port from the drop-down list.
4. Click Apply.
FIGURE 53
Showing Configured Settings for Loopback Testing
To show the adminstative status of loopback testing for each port, and the associated VLANs:
1. Click Interface, Port, Ethernet Loopback.
2. Select Show Information from the Action list.
3. Select a port from the drop-down list.
4. Click Apply.