Brocade 6910 Ethernet Access Switch Configuration Guide (Supporting R2.2.0.0) - Manual (Page 1167)

Brocade 6910 Ethernet Access Switch Configuration Guide 1111
53-1002651-02
47
Filtering and Throttling IGMP Groups
• Access Mode – Sets the access mode of the profile; either permit or deny. (Default: Deny)
When the access mode is set to permit, IGMP join reports are processed when a multicast
group falls within the controlled range. When the access mode is set to deny, IGMP join reports
are only processed when the multicast group is not in the controlled range.
Add Multicast Group Range
• Profile ID – Selects an IGMP profile to configure.
• Start Multicast IP Address – Specifies the starting address of a range of multicast groups.
• End Multicast IP Address – Specifies the ending address of a range of multicast groups.
Interface
To create an IGMP filter profile and set its access mode:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure Profile from the Step list.
3. Select Add from the Action list.
4. Enter the number for a profile, and set its access mode.
5. Click Apply.
FIGURE 384 Creating an IGMP Filtering Profile
To show the IGMP filter profiles:
1. Click Multicast, IGMP Snooping, Filter.
2. Select Configure Profile from the Step list.
3. Select Show from the Action list.
FIGURE 385 Showing the IGMP Filtering Profiles Created