Agilent Technologies Multiple Channel Controller 85330A - Manual (Page 121)

85330A Multiple Channel Controller 7-11
Remote Programming Command Reference
Standard Command Reference
RUNTime:SOURce:SOURCE1:TRIGger
Selects IMM, TTL, REMote1, or REMote2 triggering for source 1 (the RF
source).
Default The default trigger mode is TTL.
Syntax
RUNTime:SOURce:SOURCE1:TRIGger IMM | TTL
| REMote1 | REMote2;
Example
RUNT:SOUR:SOURCE1:TRIG IMM;
NOTE In the fast source stepping mode (also known as Turbo), the trigger is set to
TTL. When using more than one multiple channel controller, the
CONTroller controller would set the source trigger parameter to remote
(REMote1 or REMote2), while the REMote1 or REMote2 controller sets its
parameter to TTL.
RUNTime:SOURce:SOURCE2:TRIGger
Selects IMM or TTL triggering for source 2 (the LO source).
Default The default trigger mode is TTL.
Syntax
RUNTime:SOURce:SOURCE2:TRIGger IMM | TTL
| REMote1 | REMote2;
Example
RUNT:SOUR:SOURCE2:TRIG IMM;
NOTE In the fast source stepping mode (also known as Turbo), the trigger is set to
TTL. When using more than one multiple channel controllers, the
CONTroller controller would set the source trigger parameter to remote
(REMote1 or REMote2), while the REMote1 or REMote2 controller sets its
parameter to TTL.