Agilent Technologies Multiple Channel Controller 85330A - Manual (Page 84)

6-10 85330A Multiple Channel Controller
Programming
To Use Direct Control
Other examples:
OUTPUT 70918;”ROUT:CLOS 2,(@103);”
Switch Port 2, SCU address 1, channel 3.
OUTPUT 70918;”ROUT:CLOS 1,(@2);”
Switch Port 1, SCU address 0, channel 2.
OUTPUT 70918,”ROUT:CLOS 1,(@132);”
Switch Port 1, SCU address 1, channel 32.
Sending multiple switch addresses is possible. In the following example:
•
An example is provided for standard systems (SCU address 0).
•
An example is provided for a typical custom system, with an SCU
address of 1.
Both examples select channel 1, 2 and 3 in sequence.
NOTE Because the switches are SP2Ts or SP4Ts, when a channel on a module is
closed, all other channels on that module are open. For example, when 1 is
closed, 2, 3 and 4 are open; when 2 is closed, 1, 3, and 4 are open.
OUTPUT 70918;”ROUT:CLOS 1,(@1,2,3);”
example for standard systems
OUTPUT 70918;”ROUT:CLOS 1,(@101,102,103);”
example for custom systems
Another method of executing the above command is
OUTPUT 70918;”ROUT:CLOS 1,(@1:3);”
example for standard systems
OUTPUT 70918;”ROUT:CLOS 1,(@101:103);”
example for custom systems
The colon : represents 1 through 3 (or 101 through 103).
To set a delay between the closing of each switch state, the ROUTe:DELAy
command is used. The input parameter is time in micro-seconds.
10 OUTPUT 70918;”*RST;”
Reset the 85330A.
20 OUTPUT 70918;”ROUT:DELA 10000;”
Set the time between switch states in micro-seconds.
30 OUTPUT 70918;”ROUT:CLOS 1,(@101:104);”
Close switch state 101 through 104.