Agilent Technologies Multiple Channel Controller 85330A - Manual (Page 45)

85330A Multiple Channel Controller 2-15
Performance Verification
Verifying Remote Ports 1 and 2
Verifying Remote Ports 1 and 2
Equipment Required
•
Jumper (see below)
•
Soldering iron
•
2 jumper wires
Jumpers Figure 2-6 shows the jumper assembly that can be used to verify remote port
1 and remote port 2. Using Agilent part number 1251-8863, solder one wire
from pin 6 to pin 8, and another wire from pin 7 to pin 9. A connector hood
is recommended for the 9-pin connector, such as L-com (part number
SDC9AG) (http://www.L-com.com).
Figure 2-6 Jumper Assembly