Vaisala Hydromet Data Collection Platform - Manual (Page 126)

User’s Guide ______________________________________________________________________
124 __________________________________________________________________M210785EN-E
second cell in the new report. Your actual report is now linked to
the container report.
Configuring Polled Report Sending
The reports created with Lizard can be sent either automatically when
created using timers, they can be polled, or both. When the reports are
polled, the setup must first receive a poll message through the
communication port before the report is sent.
Note that you can choose both report sending modes (polled or timer
enabled) by entering the polled report sending parameters and selecting
the Timed sending enabled check box.
In the Polled report sending frame, you can define the poll source and
the pollstring. The poll source is the communications port or device
where the pollstring or the poll message is received from. The pollstring
is the poll message, which must be received before the polled report is
sent.
If you include %I in the pollstring, a station identifier is added to the
poll command. If multiple stations run the same setup and thus have the
same poll command(s), only the station with a matching identifier will
respond to the poll. The station identifier is set to the QML logger static
parameters with the name sid. Changing the station identifier requires a
reset after the new value has been set.
An example of how to configure transmission parameters for a report
sent through a communications port is shown in
Figure 59 on page 120 .
An example of what the transmission parameters of a report sent to a
device might look like is shown in
Figure 60 on page 125 .