Vaisala Hydromet Data Collection Platform - Manual (Page 37)

Chapter 3 ____________________________________________________________ Getting Started
VAISALA_______________________________________________________________________ 35
0802-108 Figure 12 New Setup Window
3. The new setup then appears as the current setup in the Configure
Setup frame. Enter a description for the setup into the Description
box; refer to
Figure 11 on page 34 .
4. Open the first Wizard view by clicking Next on the lower right of
the view.
If you have disabled the Wizard tool but wish to use it for this
setup, you can open the first view of the Wizard tool by selecting
Wizard from the View menu. Refer to
Figure 13 on page 36 .
If you have disabled the Use Wizard for new setups option but
wish to enable it again, refer to section
Enabling Wizard for New
Setups on page 33 .
NOTE If the version you select is higher than the one your QML logger
actually has, the logger will not run the setup file.