Vaisala Hydromet Data Collection Platform - Manual (Page 146)

User’s Guide ______________________________________________________________________
144 __________________________________________________________________M210785EN-E
Static Parameters
Creating Static Parameters
Lizard Setup Software provides an interface for creating setup-specific
static parameters to be used, for example, as station-dependent
parameters or as calculation factors. This interface in the Setup view is
only available on the Advanced user level.
0711-085 Figure 67 Setup View: Static Parameters Tab
The list in the Static Parameters tab shows all the static parameters,
including the preset ones. Refer to
Figure 67 on page 144 . User-editable
entries are listed in bold font. The Default column shows the default
values for each parameter.
NOTE The default value is written to the logger memory only when the static
parameter does not have an existing value. For example, if the sname
parameter already has the value MAWS1 and a new setup is generated
with sname = MAWS2, the existing sname value (MAWS1) is
preserved.