Vaisala Hydromet Data Collection Platform - Manual (Page 189)

Chapter 5 ________________________________________ Advanced Use of Lizard Setup Software
VAISALA______________________________________________________________________ 187
Using Static Parameters with
Timers
It is often necessary to change the interval or synchronization time of
timers. You can define these to be read from static parameters. Static
parameters can also be changed at runtime by using the spset command.
First, it is recommended that you create the parameters to be used in the
Static Parameters tab of the Setup view.
0711-106 Figure 91 Setup View: Static Parameters Tab
To change an interval or synchronization, proceed as follows:
1. Go to the Timers view.
2. Right-click the timer to be modified either in the Interval or the
Synch time column. Select Advanced edit from the list. The Edit
Timer window opens; see
Figure 92 on page 188 .
NOTE The Measure field has to be changed to seconds. In order to change it,
double-click the measure field of the static parameter in question and
select second.