Vaisala Hydromet Data Collection Platform - Manual (Page 77)

Chapter 4 ____________________________________________ Basic Use of Lizard Setup Software
VAISALA_______________________________________________________________________ 75
Selecting Equipment
In the Equipment view, the Select sensor frame is divided into two list
boxes. The Available list box contains all the available sensors or
auxiliaries. The Selected list box contains two lists displaying both the
type and name of the selected item.
To select the equipment used with the QML logger, proceed as follows:
1. Select the sensor to be added from the Available list.
2. Either drag it into the Selected list box, or click the Add button.
3. To assign connectors automatically, select the Use Defaults check
box.
4. Each selected item is then referred to with its type and is assigned
a unique name showing an identifying number. The name is
automatically highlighted suggesting that it can be changed to a
more descriptive one.
Removing Equipment
To remove a sensor from the setup, proceed as follows:
1. Select the equipment to be removed by clicking on the appropriate
row in the Selected list box.
2. Click the Remove button.
The equipment is removed from the setup.
NOTE All equipment are not automatically assigned a connector. If this is the
case, the connector has to be assigned manually, otherwise the
equipment is not connected and will not show anywhere else in the
setup.
NOTE Equipment cannot be removed if its measurement results have been
used in calculations or reports somewhere in the setup. The
measurement results have to be removed from these places first.