Vaisala Hydromet Data Collection Platform - Manual (Page 82)

User’s Guide ______________________________________________________________________
80 ___________________________________________________________________M210785EN-E
To edit the measurement name, proceed as follows:
1. Double-click the name.
2. Erase the old name and type in a new one. The name is
automatically saved when you press ENTER or click on another
measurement row.
The name may consist of the following characters: A ... Z, a ... z, 0 ... 9,
and _. No spaces are allowed.
The measurement names used should be unique, thus no name can refer
to more than one measurement in this setup.
Configuring Measurement
Parameters
Typically, you can configure only the validation values of the
parameters. These validation parameters set the limits for the
measurement values. If the measurement values exceed or go under
these limits, the measurements will be reported as missing.
Validation parameters include such values as the minimum and the
maximum values and the maximum change.
The basic set of sensors is automatically configured, so the values in the
Configure frame do not necessarily need to be changed.
If the Configure frame is empty, the measurement has no configurable
parameters.
In case you have changed the parameters but want to return to the
default settings, click the Set Default button.
NOTE Since only the measurement name, instead of both the equipment
name and measurement name, will be used in the setup from this point
on, it is recommended that you change the name to one that is
meaningful to you and thus easy to remember.
NOTE The information pane with general help information is available on all
the configurable items in case you need more detailed information.