Agilent Technologies 34401A - Manual (Page 52)

To Use Reading Memory
The multimeter can store up to 512 readings in internal memory.
The following steps demonstrate how to store readings and retrieve them.
1 Select the function.
Select any measurement function. You can also select Null, Min–Max,
dB, dBm, or limit test. You can change the function at any time during
reading memory.
2 Select the single trigger mode.
Notice that the Trig annunciator turns on. When reading memory is
enabled, readings are stored when you trigger the multimeter.
For this example, single triggering is used to store readings. You can also
use auto triggering or reading hold.
3 Turn on the menu.
A: MEAS MENU
4 Move across to the SYS MENU choice on this level.
D: SYS MENU
5 Move down to a level to the RDGS STORE command.
1: RDGS STORE
Single
> > >
∨
Shift <
On/Off
Chapter 2 Front-Panel Menu Operation
To Use Reading Memory
46