Allied Telesis AT-S63 - Manual (Page 102)

Chapter 8: File Downloads and Uploads
102 Section II: Advanced Operations
Figure 29. System Utilities Tab
3. In the TFTP Server IP Address field, enter the IP address of the
network node that has the TFTP server software.
4. For the TFTP Operation parameter, click the Download button.
5. Select the TFTP Remote Filename field and enter the name of the
configuration file that is stored on the TFTP server. The filename
extension has to be “.cfg”.
6. Select the TFTP Local Filename field and enter a name for the file.
This is the name the switch uses to store the file in its file system.
7. For the TFTP File Type parameter, select one of the following:
 Config - Select this option if you want the master switch to
immediately begin to use the new file as its active configuration file
after storing the file in its file system.
 File - Select this option to store the configuration file in the file
system in the master switch. You would use this option if you did
not want the stack to immediately begin to use the new
configuration file and planned to designate it as the active
configuration file at a later time.