Allied Telesis AT-S63 - Manual (Page 119)

AT-S63 Management Software Web Browser User’s Guide
Section II: Advanced Operations 119
6. Click the Apply button to create the new syslog output definition. If the
status of the output definition is enabled, the switch immediately
begins to send the event messages to the syslog server.
7. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Type Sets the output definition’s type. The only
option is Syslog.
Syslog Server IP Address Specifies the IP address of the syslog
server.
Facility Level Sets the numerical code the master
switch adds to the entries when it sends
them to the syslog server. The options
are:
Default - This setting uses the functional
groupings defined in the RFC 3164
standard.
local 1 through local 7 - These settings
assign a specific identifier of 1 to 7 to the
events.
Module Selections Specifies the AT-S63 Management
Software module(s) whose events are to
be sent to the syslog server. To select
more than one, use the Ctrl key when
making your selections. The default is All.
For a list of modules, refer to Table 16 on
page 110.
Table 18. Syslog Output Definition Parameters
Parameter Definition