Configuring the snmpv3 target parameters table, Creating a target parameters table entry, Figure 56: snmpv3 target parameters table tab – Allied Telesis AT-S63 User Manual
Page 163
AT-S63 Management Software Web Browser User’s Guide
Section III: SNMPv3
163
Configuring the SNMPv3 Target Parameters Table
Here are the procedures for managing the SNMPv3 Target Parameters
Table:
“Creating a Target Address Table Entry” on page 158
“Deleting a Target Address Table Entry” on page 160
“Modifying a Target Address Table Entry” on page 161
Creating a Target
Parameters Table
Entry
To create an entry in the SNMPv3 Target Parameters Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure Target
Parameters Table and then click the Configure button to display the
SNMPv3 Target Parameters Table tab in Figure 56.
Figure 56. SNMPv3 Target Parameters Table Tab