Allied Telesis AT-S63 - Manual (Page 26)

Chapter 1: Basic Switch Parameters
26 Section I: Basic Operations
Resetting a Stack
This procedure resets a stack. The switches run their internal diagnostics,
load the AT-S63 Management Software, and perform the discovery
process. The reset can take several minutes to complete.
Note
The switches of a stack do not forward traffic during the reset
process. Some network traffic may be lost.
Note
All unsaved parameter changes are discarded when a stack is reset.
To save your changes, click the Save Config button in the
Configuration menu.
Your web browser management session with the stack ends when it
resets. You must reestablish the session to continue managing it.
To reset the stack:
1. From the Home page, click the Configuration button.
2. Click the System button in the Configuration menu.
3. Click the General tab shown in Figure 1.
4. Click the Reset button at the bottom of the tab.
5. At the confirmation prompt, click the OK button to reset the stack or
the Cancel button to cancel the procedure.
Resetting the stack ends your web browser management session. To
continue managing the stack, wait for the units to complete the
discovery process and then start a new management session.