Allied Telesis AT-S63 - Manual (Page 152)

Chapter 11: SNMPv3
152 Section III: SNMPv3
6. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Deleting a
SecurityToGroup
Table Entry
To delete an entry from the SNMPv3 SecurityToGroup Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure
SecurityToGroup Table, and then click the Configure button to
display the SNMPv3 SecurityToGroup Table tab in Figure 47 on page
150.
4. Click the radio button of the SecurityToGroup Table entry you want to
delete and then click the Remove button.
5. At the confirmation prompt, click the OK button.
Group Name A Group Name that you configured in the SNMPv3 Access
Table. Refer to “Configuring the SNMPv3 Access Table” on
page 144.
There are four default values for this field:
 defaultV1GroupReadOnly
 defaultV1GroupReadWrite
 defaultV2cGroupReadOnly
 defaultV2cGroupReadWrite
These values are reserved for SNMPv1 and SNMPv2c
implementations.
Storage Type The storage method of the entry. The possible values are:
V-Volatile - This setting prevents the stack from saving the
entry in the master configuration file. An entry with this storage
type is discarded the next time the stack is reset or powered
off.
N-NonVolatile - This setting allows the stack to save the entry
in the master configuration file when the save command is
issued. Allied Telesis recommends this storage type.
Row Status The status of the entry. All entries have a status of Active.
Table 25. SNMPv3 Security to Group Table Parameters
Parameter Description