Configuring the authenticator port parameters – Allied Telesis AT-S63 User Manual
Page 225
AT-S63 Management Software Web Browser User’s Guide
Section VI: Port Security
225
Configuring the Authenticator Port Parameters
Note
A port must be set to the authenticator role before you can configure
its parameters. For instructions, refer to “Setting the Port Roles” on
page 222.
To configure the 802.1x parameters on authenticator ports:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Network Security button to
display the 802.1x Port Access tab in Figure 85 on page 222.
3. In the switch image, use the Stack ID pull-down menu to choose the
switch that has the authenticator ports you want to configure. If the
switch is already displayed, skip this step.
4. In the switch image, click the authenticator ports you want to configure.
Selected ports turns white.
5. Click the Settings button to display the window in Figure 87.
Figure 87. Authenticator Parameters Page