Allied Telesis AT-S63 - Manual (Page 36)

Chapter 2: Port Parameters
36 Section I: Basic Operations
Configuring the Port Parameters
To configure the parameter settings of the ports in the stack:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Layer 1 button.
3. Select the Port Settings tab to display the tab in Figure 6.
Figure 6. Port Settings Tab
The Port Settings tab consists of an image of the front of one of the
switches in the stack. The Stack ID pull-down menu in the upper left
corner of the image identifies the switch. Ports that have links to end
nodes are shown as green.
4. Using the stack ID pull-down menu in the upper left corner of the
switch image, select the ID number of the switch you want to configure
in the stack and click the Apply button. You can configure only one
switch at a time. If the switch is already displayed, you can skip this
step.
5. In the switch image, click the port you want to configure. The selected
port turns white. You can configure more than one port at a time, but
they must all be the same type (i.e., all twisted pair ports or all fiber
optic ports). To deselect a port, click it again.
6. Click the Modify button to display the Port Configuration window in
Figure 7. To configure all of the ports on the switch, click Modify All.