Allied Telesis AT-S63 - Manual (Page 88)

Chapter 6: Port Mirroring
88 Section I: Basic Features
Deleting the Port Mirror
To return the destination port to normal network operations:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Layer 1 button.
3. Select the Port Mirroring tab, shown in Figure 23 on page 81.
4. Click the Modify button to display the popup window in Figure 24 on
page 82.
5. If the port mirror is not already disabled, click the Enable Mirror
checkbox to remove the check and click the Apply button.
6. Click the Modify button again.
7. Using the stack ID pull-down list in the switch image, select the stack
ID of the switch that has the destination port and click the Apply
button. (You can skip this step if the switch is displayed by default
when you clicked the Modify button.)
8. Click the destination port until it changes from white to black and click
the Apply button
9. To save your changes in the master configuration file on the master
switch, click the Save Config button in the Configuration menu.