Allied Telesis AT-S63 - Manual (Page 28)

Chapter 1: Basic Switch Parameters
28 Section I: Basic Operations
Restoring the Factory Default Values
The procedure in this section restores the factory default settings to all of
the parameters on the switches in the stack. Review the following before
performing this procedure:
 This procedure deletes all of the routing interfaces and port-based and
tagged VLANs in the stack.
 This procedure does not delete any of the files in the master switch’s
file system. For instructions on how to delete files, refer to the AT-S63
Command Line User’s Guide for AT-9400 Stacks.
 The speed of the Terminal Port on the master switch remains at its
current setting.
 Returning a stack to the default parameter values does not alter the
contents of the active boot configuration file. To reset the file to the
default settings, you must establish a local management session with
the switch after it reboots and select Save Config from the menu.
Otherwise, the stack reverts back to the previous configuration the
next time you reset or power cycle the unit.
 Because this procedure deletes the local interface on the stack, it will
not be possible to reestablish a web browser management session. To
resume managing the stack, begin a local management session.
Caution
This procedure resets the stack. Some network traffic may be lost
while the switches initialize their management software and perform
the discovery process.
Note
The AT-S63 Management Software default values are listed in
Appendix A, “AT-S63 Default Settings” in the AT-S63 Management
Software Features Guide.
To restore the default settings to the AT-S63 Management Software on
the stack:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Utilities button to display the
System Utilities tab, shown in Figure 4 on page 29.