Figure 76: configure rstp parameters tab, Table 35: rstp parameters – Allied Telesis AT-S63 User Manual
Page 197
Advertising
AT-S63 Management Software Web Browser User’s Guide
Section IV: Spanning Tree Protocols
197
4. Click the Configure button to display the Configure RSTP Bridge
Parameters tab shown in Figure 76.
Figure 76. Configure RSTP Parameters Tab
5. Configure the parameters, described in Table 35, as needed.
Table 35. RSTP Parameters
Parameter
Definition
Force Version
Specifies whether the bridge operates
with RSTP or in an STP-compatible
mode. If you select RSTP, the bridge
operates all ports in RSTP, except for
those ports that receive STP BPDU
packets. If you select Force STP
Compatible, the bridge operates in RSTP,
using the RSTP parameter settings, but it
sends only STP BPDU packets out the
ports.
Advertising