JLG 460SJ Service Manual - Manual (Page 283)

SECTION 4 - BOOM & PLATFORM
3120895 – JLG Lift – 4-19
15. Remove the wear guides (302) from the end cap (4)
and shaft (2).
16. To remove the main pressure seals (205), it is easi-
est to cut them using a sharp razor blade being
careful not to damage the seal groove.
17. Remove the thrust washers (304), from the end cap
(4) and shaft (2).
18. Remove the wiper seal (304.1) from its groove in the
end cap (4) and shaft (2).
19. Remove the piston O.D. seal (202).
20. Remove the piston I.D. seal (200). You may now pro-
ceed to the inspection process.