JLG 460SJ Service Manual - Manual (Page 368)

SECTION 6 - JLG CONTROL SYSTEM (S/N 61718 TO PRESENT)
6-52 – JLG Lift – 3120895
GEN SET CUTOUT:
13*
* Only visible if Gen Set /
Welder Menu selection is
not 0. 0
1
MOTION ENABLED: Motion enabled when generator is ON.
MOTION CUTOUT: Motion cutout in platform mode only.
0
H & T LIGHTS:
14 0
1
NO: No head and tail lights installed.
YES: Head and tail lights installed.
0
CABLE SWITCH:
15*
* Only visible under certain
model selections.
* Certain market and
model selections will alter
the default setting. 0
1
NO: No broken cable switch installed.
YES: Broken cable switch installed.
0
LOAD SYSTEM:
16*
* Only visible under certain
market selections.
* Certain market selections
will limit load system
options or alter default set-
ting. 0
1
2
3
4
NO: No load sensor installed.
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2
sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5
sec ON, 2 sec OFF).
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), platform
alarm beeps (5 sec ON, 2 sec OFF).
SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out & main lift
up, platform alarm beeps (5 sec ON, 2 sec OFF).
0
LOAD SENSOR:
17*
* Only visible if Load Sen-
sor Menu selection is not 0
and under certain market
selections.
* Certain market selections
will limit load sensor
options. 0
1
1 ON ROTATOR: Use the on-board load sensor for all models except those which use the
Leveling Platform Module.
4 UNDER PLATFORM: Use the EIM for load sensing.
1
Table 6-5. Machine Configuration Programming Information Software Version P5.3 to P6.1
Configuration Label/
Digit
Number Description
Default
Number