JLG 460SJ Service Manual - Manual (Page 387)

SECTION 6 - JLG CONTROL SYSTEM (S/N 61718 TO PRESENT)
3120895 – JLG Lift – 6-71
13 Head & Tail
LIGHTS 0=NO
1=YES Displays presence
of head and tail
lights 0
1
No Head and Tail Lights
installed
Yes
1 0
14 BROKEN Cable
switch 0=NO
1=YES Displays presence
of broken cable
switch 0
1
No Broken Cable Switch
installed
Yes
1 0
15 load SENSOR 0=NO
1=WARN ONLY
2=WARN & CUTOUT Displays presence/
function of load
sensor 0
1
2
No Load Sensor installed
Functions in Creep, Overload
Lamp Lit, Platform Alarm
Beeps Continuously
All functions cutout, flash
overload light (500mS on,
500mS off), Platform Alarm
beeps (5 sec. on, 55 sec. off,
5 sec. on)
1 0
16 angle SENSOR 0=NO
1=DIGITAL
2=ANALOG Displays presence/
function of angle
sensor 0
1
2
No Angle Sensor installed
Limit switches are installed
An analog sensor is installed
1 0
17 length SENSOR 0=NO
1=DIGITAL
2=ANALOG Displays presence/
function of length
sensor 0
1
2
No Length Sensor Installed
Limit switch installed
An analog sensor is installed
1 0
18 FUNCTION
CUTOUT 0=NO
1=BOOM CUTOUT
2=DRIVE CUTOUT
3=DRIVE CUT E & T Displays presence/
function of drive
cutout. 0
1
2
3
No Drive Cutout
Boom Function Cutout While
Driving Above Elevation. (CE)
Drive Cutout Above Elevation
Drive Cutout Above Elevation
And Tilted
1 0
19 ground alarm 0=NO
1=DRIVE
2=LIFT DOWN
3=BOOM & DRIVE Displays/adjusts
ground alarm pres-
ence/function 0
1
2
3
No Ground Alarm installed
Travel alarm – sounds when
the drive function is active.
(Option)
Descent alarm – sounds
when either lift down is
active. (Option)
Motion alarm – sounds when
any function is active.
(Option)
1 0
Table 6-8. Machine Configuration Parameters