JLG 460SJ Service Manual - Manual (Page 67)

SECTION 3 - CHASSIS & TURNTABLE
3120895 – JLG Lift – 3-15
9. Place spacer (1H) onto spindle (1A) in hub (1G).
NOTE: Make sure the retaining ring is securely seated in the
groove.
10. Place retaining ring (1I) over the spacer onto spindle
(1A) in hub (1G).
11. At this point the hub-spindle sub-assembly is com-
plete.
Main Assembly
BEWARE OF SHARP EDGES IN COUNTERBORE WHEN INSTALLING
THE O-RING
1. Grease o-ring (5) and place it into the counterbore in
hub (1G).
NOTE: O-ring may be stretched or pinched together to make
it fit the counterbore exactly.
2. Oil all exposed surfaces inside hub (1G).